Comparison of numerical and laboratory modeling in the estimation of the labyrinth weirs discharge coefficient:Investigating different overflow location modes

Document Type : Original Article

Authors

1 PhD Candidate of Water Engineering- water structures, Department of Water Engineering, Ferdowsi University of Mashhad, Iran.

2 Associate Professor, Department of Water Engineering, Faculty of Agriculture, Ferdowsi University of Mashhad, Iran

3 Professor, Department of Water Engineering, Faculty of Agriculture, Ferdowsi University of Mashhad, Iran

4 Post Graduate of Water Engineering- water structures, Department of Water Engineering, Ferdowsi University of Mashhad

Abstract

Labyrinth weirs are considered from important hydraulic structures to regulate the water level and control flow in canals, rivers and dam reservoirs. In this research a comparison of numerical modeling with softwareFLOW-3Dwith laboratory results in the case oflabyrinth weirs has been carried out. To review and evaluate different scenarios of overflow location like changing the geometric arrangement and labyrinth weirshas been considered In terms of form and direct or reverse direction weirs discharge coefficient. Therefore, selected a labyrinth weirs model with three side angles 15 and 22.5 and 30 degrees have been selected. To calibrate the selected models according to laboratory conditions5 discharge in the range of 2.8 to 18.1 liters per second were chosen to pass them. Numerical model after calibration Simulated with laboratory results different scenarios of overflow application. Results show outputs of numerical model with experimental results good coordination. In the same vein amount of discharge coefficient in weirs form-1 and the inverse form increase of discharge coefficient with increasing the side of the weirs has been found.

Keywords

References

اژدری مقدم،م.، امانیان،ن.، جعفری ندوشن،ا. 1388. بهینه­یابی هندسه­ی سرریز کنگره­ای مثلثی با استفاده از مدل فازی- عصبی و الگوریتم ژنتیک (مطالعه­ی موردی سد Hyrum در ایالت یوتای آمریکا). مجله مدل­سازی در مهندسی. 7. 19: 69-57.
تور،ن.، حیدرنژاد،م.، احدیان،ج. 1396.  بررسی تاثیر تغییر طول سرریز بر مشخصات هیدرولیکی سرریزهای زیگزاگی با پلان ذوزنقه ای . اولین کنفرانس ملی رویکردهای نو در مهندسی عمران،معماری و شهرسازی.
یاسی، م.، محمدی،م. 1386. بررسی سرریزهای زیگزاگی با پلان قوسی، علوم و فنون کشاورزی و منابع طبیعی. 11. 41: 12-1.
Falvey, Henry. 2003. Hydraulic design of labyrinth weirs. Reston, VA: ASCE Press (American Society of Civil Engineers), Pub., Virginia,USA. 49-54.
Parvaneh, Ali. Kabiri-Samani, Abdorreza and Nekooie, Mohammad Ali. 2016. Discharge Coefficient of Triangular and Asymmetric Labyrinth Side Weirs Using the Nonlinear PLS Method. Journal of Irrigation and Drainage Engineering 142.11.
Paxson,G and Bruce,S. 2006. Labyrinth spillways: comparison of two popular USA design methods and consideration of non-standard approach conditions and geometries. Proceedings ofthe International Junior Researcher and Engineer Workshop on Hydraulic Structures. 37-46.
Wilson, Nichols, Hirt and Stein. 1988. SOLA-DM:A numerical solution algorithm for transient three-dimensional flows (No. LA--11161-MS). Los Alamos National Lab.
Iranian Journal of Irrigation & Drainage
Volume 12, Issue 3 - Serial Number 69
September and October 2018
Pages 503-511

Files

Share

How to cite

Statistics